Two-Part Silicone Sealant REBID

This should come as a kit of two sausage cartridges (part A and part B) that work with the dual sausage pneumatic gun. This product should conform to the Kentucky 2026 Standard Specification for Road and Bridge Specifications section 807.03.05(B). ****************************************************** ***ONLY ONLINE BIDS WILL BE ACCEPTED FOR THIS RFB.*** Emailed and hard copies delivered by any method WILL NOT BE ACCEPTED. See attached document How to Respond to an Online Bid through the Kentucky Vendor Self Service site (updated).pdf. Please enter contact person, phone number and email in the Comments Section. Vendors should review and update, if necessary, all addresses and contact persons for their account prior to bid submission. This information will carry forward to a contract if awarded, therefore please ensure all information is correct. This equipment is used to apply the two part (parts A & B) sausage cartridges that make up the silicone sealant. The model should be the Albion AT1500X which must be able to dispense dual component compounds. This should be a two-component rapid curing liquid polymer. The material is used to form the edge of broken concrete and provide a surface for the two part silicone sealant to adhere. This material must cure to a dense, semi-flexible polymer that is resistant to chemicals, weather, abrasion, and impact. This should be the WaboCrete II. The WaboCrete ll product comes with part A activator (1/2 gal container), part B resin (1 gal container), and part C aggregate (5 gal container-60 lbs). This nozzle must fit on the Albion AT1500X. This nozzle is for one time use and then is disposed. This material is needed to support the two part silicone sealant in the expansion joint until the sealant cures. This foam backer rod must be 2 1/2 in. in diameter and sold either in rolls or standard lengths. This material is needed to support the two part silicone sealant in the expansion joint until the sealant cures. This foam backer rod must be 2 in. in diameter and sold either in rolls or standard lengths. This material is needed to support the two-part silicone sealant in the expansion joint until the sealant cures. This foam backer rod must be 1 1/2 in. in diameter and sold either in rolls or standard lengths. This material is needed to support the two-part silicone sealant in the expansion joint until the sealant cures. This foam backer rod must be 1 in. in diameter and sold either in rolls or standard lengths.